Cabling and bracing can steady a tree like that. North Star Tree Services Co. installs through-bolts and steel brace rods to cut down the movement, and one visit settles whether your tree needs any of it.
How do I know if my tree needs cabling or bracing?
Cracks where a big limb meets the trunk, a split running down the trunk, or a lean that's getting worse are the signs. A tree that sways hard over your house or driveway is also worth a look. Not every stressed tree needs hardware, and we'll say so if yours doesn't.
We check how the tree is put together, how wide any crack has opened, and how much the tree moves before we suggest hardware.
This work can lead into tree planting. Looking for tree service in Redding? See every service we offer.
Helpful next: What Happens During Tree Service: The Steps Explained · How to Choose a Tree Service Contractor: What a Good Quote Spells Out
How does North Star Tree Services Co. install the support system?
We run machine-threaded steel brace rods through the holes in the wood, fit a washer and nut on the rod, and tighten the hardware. The washers sit on the wood surface. We don't countersink them into it. Through-bolts and brace rods are the equipment for this job.
After installation we inspect the system and adjust the hardware as needed. It's not set and forget. Redding's January lows average near 38°F and its July highs near 100°F, about 62 degrees of seasonal range, so we recheck the hardware rather than assume it still holds.

What does cabling and bracing cost in Redding?
Tree cabling installation typically runs $250 to $475. Ask for that range on the phone and you'll get it. The firm number comes after we've seen the tree in person. What moves the price is the tree itself and how much support it needs, and the quote is on paper before we touch it.
A smaller tree with one problem limb should land toward the low end. A bigger tree that needs more hardware pushes toward the top. Each rod and its placement is itemized on the quote.
Will this guarantee my tree won't fail?
No. Support systems reduce movement, but they don't eliminate the risk of failure. The hardware helps hold a weak tree together. It doesn't repair the weakness itself. We'll tell you plainly what the system can and can't do for your tree.
That's why we inspect and adjust the hardware after it's installed. If a tree is too far gone for bracing to help, we'll say so and talk through other options, including removal.
What's the next step if I think my tree needs help?
A visit settles whether the tree needs support at all. Nothing is booked or committed on the first call, and a tree that's fine as it is gets told so.
What the Job Includes
In plain terms, steps like these come up:
- Have a qualified arborist assess the tree, its structural defects, and whether the tree is a suitable candidate for support.
- Define the support objective and determine the appropriate cable and brace-rod system for the weak union or stems.
More Ways We Can Help
Fast Scheduling
Call (530) 319-6300 and describe the job, you'll get an honest answer.
Estimates · No-pressure scheduling